CYP PU-USB-KIT, Руководство по эксплуатации, Страница: 8 / 12

8
6.2 Receiver Front & Rear Panels
USB 4 2 3 1
CAT 5e/6 to USB Receiver
DC 5V Link Pair
Select USB Link CAT 5e/6 In
Power
USB
Link
Receiver
1 2
On
3 4
2 3 4 5 6 7 1
1
USB Link:
This LED will illuminate when the transmitter has linked
with receiver’s USB signal. User are only able to control the USB in (the
source device) when this LED is not illuminated.
2
Power LED: This LED will illuminate when the device is plugged with
power supply.
3
DC 5V: Plug the 5V DC power supply into the unit and connect the
adaptor to an AC outlet.
4 Link Pair Select:
This dip switch allows user with multi-pair setting for
link up to 16 pairs of the devices with single IP router. Each pair must
have the same dip switch setting in order to pair to the right device
setting. The factory default setting is at 0000. (This function is not
available yet with the first generation of the product)
Note: To activate the setting a re-power on is required after each new
setting.
5
USB Link button:
Press this button to allow the receiver to be link up
or unlink with the transmitter’s USB input.
Note: To activate the link a re-power on is required after each button
pressed.
6
CAT5e/6 Out: This slot is to connect with CAT5e/6 cable with receiver
side’s CAT5e/6 input. When both transmitter and receiver is connected
the green LED will illuminate. When the data is sending the yellow
LED will be blinking.
7 USB 1~4:
These slots are where you connect your devices, such as
keyboard, mouse, USB storage device or etc with USB cables.