CYP PU-USB-KIT, Руководство по эксплуатации, Страница: 7 / 12

7
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front & Rear Panels
USB to CAT 5e/6 Transmitter
DC 5V Link Pair
Select CAT 5e/6 Out
Power
Link
On/Off
USB In
USB
Link
Transmitter
1 2
On
3 4
2 3 4 5 6 7 1
1 USB Link:
This LED will illuminate when the transmitter has linked
with receiver’s USB signal.
2 Power LED
: This LED will illuminate when the device is plugged with
power supply.
3 DC 5V:
Plug the 5V DC power supply into the unit and connect the
adaptor to an AC outlet.
4
Link Pair Select:
This dip switch allows user with multi-pairs setting
for link up to 16 pairs of the devices with single IP router. Each pair
must have the same dip switch setting in order to pair to the right
device setting. The factory default setting is at 0000.
Note:
To activate the setting a re-power on is required after each new
setting.
5
Link On/Off button: Press this button to allow the receiver to be link
up or unlink with the transmitter’s USB input.
Note:
To activate the link a re-power on is required after each button
pressed.
6 USB In:
This slot is to connect with PC/Laptop for input source signal
with USB B type cable.
7 CAT5e/6 Out:
This slot is to connect with CAT5e/6 cable with receiver
side’s CAT5e/6 input. When both transmitter and receiver is connected
the green LED will illuminate. When the data is sending the yellow
LED will be blinking.