9
6.2 Rear Panel
IR
Blaster
IR
Extender
CAT5e/6 OUT
MODE
LINK
LAN
RS232 IN
DC 24V
POWER
2
1
3
4
5
6
7
1
Power LED:
This LED will illuminate when the device is connected to
an active power supply.
2
DC 24V:
Connect the 24 V DC power supply to the unit and plug the
adaptor into an AC outlet. Only one unit requires powering if both the
Transmitter and Receiver are both PoE compatible.
3
RS-232 IN:
Connect to a PC or RS-232 control system with a D-Sub 9
pin male cable for the transmission of RS-232 commands.
4
LAN:
Connect to an active network for LAN serving. When any compatible
LAN equipped receivers are connected, this allows the network access
(including internet access if available) to be shared between any
connected LAN equipped receivers. Connect any Ethernet equipped
device e.g. a Smart TV or games console to the LAN port of a receiver for
that device to share the network/internet access.
Warning: DO NOT connect the LAN connection to the CAT5e/6/7 port.
Doing so may cause a power shutdown and may damage the device.
5
IR Blaster:
Connect the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
6
IR Extender:
Connect the supplied IR Receiver cables for IR signal
reception. Ensure that remote being used is within the direct line-of-
sight of the IR Extender.
7
CAT5e/6/7 Out:
Connect to the Receiver unit with a single CAT5e/6/7
cable for transmission of all data signals.
MODE LED:
This LED will illuminate when the power is connected.
Link LED:
This LED will illuminate when connected to a Receiver unit
that is connected with a TV/monitor that is displaying the signal.