CYP PU-1109KIT, Руководство по эксплуатации, Страница: 8 / 16

8
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter
Rear
HDMI
Bypass
HDMI In
LAN 1 LAN 2 LAN 3
1 2 3
Front
Power
DC 24V
Extender Blaster RS232 In
CAT5e/6 Out
Link
IR 2 IR 1
4 5 6 7 8 9 10
1 HDMI Bypass:
Connect to a HDMI TV/monitor for instant display of
the HDMI input source signal.
Note
:
When the HDMI bypass is connected, no signals will be transmitted
to the receiver side. Therefore, unplug this connection after confirming
that the correct image is displayed
2 HDMI In:
Connect to the HDMI equipped source equipment such as
DVD or Blu-ray player.
3 LAN 1/2/3:
The LAN connections can be used to connect and share up
to 6 ethernet connections (3 at the receiver end, 3 at the transmitter
end), including computers, routers and media servers.
4 Power LED:
The red LED will illuminate when the 24 V DC Adaptor is
connected to the AC outlet.
5 DC 24V:
This slot is where you plug the 24 V DC power supply into the
unit and connect the adaptor to an AC outlet.
6 IR 1 Blaster:
Connect the IR blaster cables included in the package for
IR signal transmission. The related IR receiver port is IR1 Extender.
7 IR 2 Extender
: Connect the IR receiver cables included in the package
for IR signal reception.The related IR transmitter port is IR2 Blaster.
8 RS-232 In:
This slot is to connect with PC/laptop /Control Device with
D-Sub 9-pin male cable for sending RS-232 commands.
9 Link LED:
This yellow LED will illuminate when the both CAT5e/6
input and output signal is connected.
10 CAT5e/6 Out:
Connect the transmitter and receiver via a single
CAT5e/6 type cable for all data transmission.