CYP CMSI-424L, Руководство по эксплуатации

Страница: 9 / 24

4
6.2 Rear Panel
1
IR IN IR OUT
2
IR IN IR OUT
3
IR IN IR OUT
4
IR IN IR OUT
HDMI OUT CAT5e/6 OUT
A
CAT5e/6 OUT
B
HDMI OUT CAT5e/6 OUT
C
CAT5e/6 OUT
D
HDMI IN 1 HDMI IN 2 HDMI IN 3 HDMI IN 4
DC 24V
1 2
3 4
V+
GND
GND GND
V+
IR OUT
IR IN
ALL
SERVICE
RS232
IP
CONTROL
2 3
5
11 10
1
4
8 6
7 9
1 RS-232: Connect to a PC or control system with D-Sub 9-pin cable
to control the unit with RS-232 commands.
2
IP CONTROL: Connect to an active network for Telnet/WebGUI
control (refer to Sections 6.8 and 6.9)
Warning: Please do not connect this port directly to the PC/Laptop
as the Telnet function will not work.
3 SERVICE: Manufacturer use only.
4 HDMI OUT and CAT5e/6/7 OUT A/C: Simultaneous HDMI and
HDBaseT CAT5e/6/7 output. The HDMI output can be connected
directly to a display or to a point-to-point transmitter/receiver set.
Connect the CAT5e/6/7 output to a compatible receiver unit to
extend the signal up to 60 m.
5 CAT5e/6/7 OUT B/D: Connect from these CAT outputs to the CAT
input port of the receiver units with a single CAT5e/6/7 cable for HDMI
Audio/Video and IR control signal transmission.
Warning: Please do not connect the CAT5e/6/7 output into the
receiver's LAN port.
6 HDMI IN 1~4: Connect to the HDMI input source devices such as a
DVD player or a Set-top Box with HDMI cable or DVI to HDMI cable.
7 IR IN 1~4: Connect the IR receivers to the IR ouputs. Ensure that
the remote being used is within the direct line-of-sight of the IR
receiver. It will transmit the IR signal to the selected IR OUT output
(from 1~4) and IR OUT ALL.
8 IR OUT 1~4: Connect the IR blasters to the IR outputs. Place the IR
blaster in direct line-of-sight of the equipment to be controlled. It
will transmit the signal as selected in the settings.
9 ALL IR OUT: Connect an IR blaster to this IR output. Place the IR
blaster in direct line-of-sight of the equipment to be controlled. It
will transmit all IR signals received from IR IN 1~4.