Cynosure Acclaim 7000, Техническое руководство

Страница: 51 / 74

Apogee Elite/Apogee 5500/Acclaim 7000 850-1257-000, Rev. 2 Page 47 of 70
Technical Guide
Replacing the Glass Only, Apogee 5500/Acclaim 7000
1. Remove the holder as described on page 46.
2. Remove the damaged glass and any adhesive remaining on the holder. Clean with
methanol.
NOTE : The beam combiner is coated on one side only. This coated surface must face the
laser rod. A black dot on the glass indicates the uncoated surface. Remove this dot using
methanol and a lens tissue or cotton swab before gluing the new glass in place.
3. Use optical grade adhesive to secure the new glass to the holder so that the coated surface
is toward the laser rod. Let it dry.
4. Reinstall the holder and glass in the beam combiner mount in the correct orientation.
5. Reverse above steps for installation.
6. Verify alignment of the aim LED, and then realign if necessary.
7. Verify the energy monitor, and if necessary, recalibrate as described in the Final Test and
Calibration Procedure.
Replacing the Aim LED
If the aim beam is not visible and power is being supplied (only in Ready Mode), the aim LED
must be replaced. The LED can be switched on and off by S2 on the Control Logic PCB.
NOTE: On the Apogee Elite system, the aiming beam diode is located on the Nd: YAG turning
mirror mount.
1. Disconnect P14 from LED.
2. Loosen the three adjustment screws and remove the LED assembly and holder.
3. Loosen the 4-40 setscrew in the holder to remove the LED assembly.
4. Replace the LED assembly.
NOTE: If only the LED is provided and not the complete assembly, resolder the new
LED making sure that the anode (+) of the LED (long lead) is connected to the red wire.
5. Verify LED alignment and readjust if necessary.