EN - 12
4.2 Adjusting the Feet /
Adjusting Adjustable Stays
1
1.
Do not install your machine on a surface
(such as carpet) that would prevent
ventilation at the base.
•
To ensure silent and vibration-free
operation of your machine, install it on a
firm surface.
•
You can level your machine using the
adjustable feet.
•
Loosen the plastic locking nut.
X
4
2
3
2.
To increase the height of the machine,
turn the feet clockwise. To decrease
the height of the machine, turn the feet
anticlockwise.
•
Once the machine is level, tighten the
locking nuts by turning them clockwise.
3.
Never insert cardboard, wood or other
similar materials under the machine to
level it.
•
When cleaning the ground on which
the machine is located, take care not to
disturb the level of the machine.
4.3 Electrical Connection
•
Your Washing Machine requires a 220-
240V, 50 mains supply.
•
The mains cord of your washing
machine is equipped with an earthed
plug. This plug should always be
inserted to an earthed socket of 10
amps.
•
If you do not have a suitable socket and
fuse conforming with this, please ensure
the work is carried out by a qualified
electrician.
•
We do not take responsibility for
damage that occurs due to the use of
ungrounded equipment.
NOTE:
Operating your machine
with low voltage will cause the life cycle
of your machine to be reduced and its
performance to be restricted.
4.4 Water Inlet Hose Connection
3/4”
10 mm
1
3
2
4
1.
Your machine may have either a
single water inlet connection (cold)
or double water inlet connection (hot
and cold) depending on the machine
specifications. The white capped hose
should be connected to cold water inlet
and red capped hose to the hot water
inlet (if applicable).
•
To prevent water leaks at the joints,
either 1 or 2 nuts (depending on your
machine’s specifications) are supplied
in the packaging with the hose. Fit these
nuts to the end(s) of the water inlet hose
that connect to the water supply.
2.
Connect new water inlet hoses to a ¾ ˝,
threaded tap.
•
Connect the white capped end of the
water inlet hose to the white water inlet
valve on the rear side of the machine
and the red capped end of the hose to
