61
Copyright May 2020 Cycloricity Ltd.
Trip Data View
-
To enter the history trip data view, press the SW button once while the device is on. The
ODO and TTM will appear.
-
Press the UP/DOWN buttons to access the maximum speed and average speed information.
-
Press SW again to exit this view (or it will automatically exit this view after 5 minutes of
riding).
User Setup
You must configure the following functions on your device:
a.
Maximum speed.
b.
Wheel diameter (16”-28”).
c.
Unit selection (Miles or Km, MPH or Km/h).
ATTENTION: Not configuring this will result in the LCD showing wrong Speed/Distance readings.
-
If the device is on, press the SW button to switch it off.
-
Press the SW button to switch it back on.
-
As soon as the LCD turns on, press and hold both the UP and DOWN buttons at the same
time for 3 seconds (till you see a number flashing on the screen). This will take you into the
LCD setup view.
-
Adjust the maximum speed. (Note: you cannot achieve speeds greater than 25km/h unless
you obtain the CycloTricity de-restriction codes after signing the relevant disclaimer. Merely
setting a high speed on this step will not unlock the full power of your Rear Drive Kit).
-
Press the SW button to move on to the wheel diameter. Use the UP/DOWN button to set
the correct diameter.
NOTE: If the wheel diameter is not configured properly, the display will give you wrong
outputs when it comes to power, speed, time distance etc.
-
Having adjusted the wheel diameter, press the SW button to move on to the unit selection.
Use the UP/DOWN buttons to change between Km/h and Mph. The distance units (miles or
km) will be selected for you depending on which speed unit you pick.
-
Press and hold the SW button to save the settings and switch off the Display.
