cyclotest 2 plus, Инструкция по эксплуатации, Страница: 28 / 87

Operating the unit Operating the unit
.... Ich bin mir sicher. .........................
EN-54 EN-55
On the first day of your period, press and hold the Cycle Start button
until you hear a beep confirming the input.
On the next morning of your cycle, directly after waking up and be-
fore getting up, measure your wake-up temperature. Put the sensor
in your mouth and place it in one of the pockets under the tongue,
press the Measurement button briefly and wait until it beeps.
Highly fertile phase
Fertile phase
Infertile phase
Read off fertility status
Note:
The measurement period of +/- 2 hours is automatically estab-
lished for the current cycle with the first measurement on the morn-
ing after the cycle start input.
1
2
3
Inputting the start of your cycle
Measuring your waking temperature
Easy use in 3 steps! Input the start of your cycle
Press the small round Start button during
initial operation to start the cycle and to
start each subsequent new series of cycle
measurements.
You enter the start of the cycle with the Start
button. This should be done if possible on
the first day of your menstruation. Press the
Start button firmly and hold down until the
input is confirmed with a beep.
You can enter the start of the cycle independently of a measurement,
i.e. also in the afternoon or the evening.
Fig. no. 1
Your display looks like this if the input has
been successful.
Fig. no. 2
If your display looks like this, the input has
not been made.
In this case, wait until the unit has switched itself off and then repeat
the input. Important: press the Cycle Start button firmly and for a
sustained period.
Note:
cyclotest® 2 plus cannot store any measurement results if the
start has not been input.
1