11
TROUBLESHOOTING
Problem
Possible Cause
Solution
The scooter
won’t start.
Power Switch is
i
n OFF
position.
Battery is no
t
charged.
Wires or connectors are loose
or unplugged.
Switch the Power Switch to ON.
Charge the battery full
y
. Charge the battery
for
7 hours for the very first time and 4 hours for
a
subsequent charging.
Dismantle the scooter and check the power
connection and controller connection for any
loosening. Re
connect
them when necessary.
Scooter run
time is short.
Battery requires charging.
The battery will not accept
full charge.
Fully charge the battery. Charge the battery
7 hours for the very first time and 4 hours for
a
subsequent charging.
See that the charger plug is connected to
a 2
3
0V power supply.
Make sure the wall outlet
switch
is on.
Battery
may need to be replaced. Even with
proper
care, rechargeable batteries do not last
forever.
The average rechargeable battery life
is 1 to 2
years depending on scooter conditions
and use.
The scooter
runs very
slowly.
The scooter is overloaded.
The riding surface is not
suitable.
Brakes are not adjusted
correctly.
Make sure the scooter is not overloaded.
This
product is designed to sustain a maximum
of
50kg. An excessive overload triggers off
automatic protection and makes the scooter
refuse to start. Do not ride uphill or use the
scooter to tow any cargo. Do not overload the
scooter, which may cause the battery and the
electronics to age prematurely and damage the
power system.
Only ride on solid, even, clean, and dry
surfaces such as sidewalk
s
and flat ground.
Refer to the instruction manual on adjusting
brakes.
Scooter
suddenly
stops working.
Reset button has tripped.
The reset button (on the left side of the battery
box) will automatically trip up and turn off the
power if the motor is overloaded.
An excessive overload (steep incline or too
heavy of a rider) could have caused the motor
to overheat and tripped the breaker. If this
occurs (scooter suddenly stops running) wait
a
few seconds and then push the reset button
in
to reset the circuit. Avoid repeatedly tripping
the breaker.
Check all wire and connectors to make sure
they are connected tight.
Scooter makes
grinding or loud
noises when
motor is running.
Chain is dry.
Apply lubricant to the chain.
EXPLOSIVE VIEW
Part #
1
2
3
4
5
6
7
8
9
10
11
Part Designation
Front Fork
Front Wheel
Charging Socket
Battery Box
Kickstand
Motor Cover
Decorative Cover
Lower Nylon Ring
Frame
Brake
Power Switch
Upper Nylon Ring
Part #
12
13
14
15
16
17
18
19
20
21
22
Part Designation
Controller
Battery
Brake Pedal Cover
Motor Assembly
Rear Wheel
LOGO Cover
Foot Board
Hand
Grip
T
hrottle
knob
Handle Bar
ON/OFF Switch
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
12