18
Cyclone Insert Installation - English
Install the BX600/CLX60 Range Hood
BX600/CLX60 INSERT HOOD INSTALLATION
This appliance requires 120V 60Hz electrical supply and
connection to an individual properly grounded branch circuit
protected by a circuit breaker or time delay fuse.
• Turn off power circuit at the service panel before wiring
this unit.
• All electrical work must be done by a qualified electrician
in accordance with all applicable codes and standards.
This range hood must be properly grounded.
WARNING
• At least two installers are required due to the weight and
size of the hood.
CAUTION
Figure 2.
Figure 1.
Prepare for Installation
1. Unpack range hood and check contents. Note: Be cautious of
sharp edges within the unit.
2. Cut the insert cutout at the bottom of the cabinet using the
given cutout measurements on page 18 (Figure 1).
3. Locate the cutout at the center of the bottom of the cabinet.
1. Remove outer baffle filters of range hood (Figure 1).
2. Hold range hood upright, and insert range hood upward into
cabinet cutout. Mount the insert range hood to the cabinet
using four screws from inside the range hood (two screws on
each side). In addition, use four screws to secure the hood on
to cabinet surface (Figure 2).
3. Place baffle filters back into place.
4. Connect the power plug to the junction box.
Figure 1.
