URL
http://www.cyclogic.net
[email protected] / [email protected]
Tel
+82 317099303
CL-MC03** Series Modbus Interface Module Installation Instructions, Oct. 2016
@2016 Cyclogic Inc.
Document Rev . 1
Modbus Interface Module
· Only use the specified cables; securely connect each so that the terminals do not bear any cable weight.
Improperly connected or short-circuited cables may produce heat and cause a fire.
· All electrical work should be performed by an authorized electrician according to local regulations and
instructions outlined in this manual.
Capacity shortage to the power supply circuit or improper installation may result in electrical shock or fire.
· Do not make any modifications or alternations to the device.
Modifications or improper repair may result in electric shock or fire. Consult your dealer for repair.
· Properly install the device according to the instructions in this Installation/Instruction Manual.
Improper installation may result in electric shock or fire.
Caution
· Do not install the device in a location where a flammable gas leak may occur.
Gas may leak, collect around the device, ignite, and/or explode.
· Do not install the device in environments where large amounts of oil (including machine),
sulfidizing gas, or acidic, alkaline, chemical sprays are present.
These types of substances may damage internal parts, cause device performance to be reduced, and
cause electrical shock.
· Do not install the device in a bathroom, kitchen, or any room where steam could form.
Condensation may develop and cause electrical shock and/or the device to malfunction.
· Do not install the device in a location where there is direct sunlight or where the temperature may
become greater than 40°C (104°F) or less than 0°C (32°F).
If the device is installed in such place, it may result in deformation or malfunctions.
· When installing the device in a hospital, communication facility, etc., provide sufficient protection
against frequency noise.
Power generators and inverters, high-frequency medical, or radio communication equipment may
interfere with the normal operation of this device. Subsequently, the device may also affect medical
treatment, image broadcasting, etc., by creating frequency noise.
· Include some slack in the power supply wires.
Tension on the wires may cause them to excessively heat up and/or break, resulting in a fire.
· Use standard wires with the proper current capacity
to avoid the possibility of current leak, excessive heat, and/or fire.
· Do not touch the main circuit board; also, make sure that dust does not accumulate on the circuit
board.
· Do not immerse the device in water.
Doing so may lead to electric shock or malfunctions.
