CYBEX VR3 Leg Extension, Руководство владельца и по обслуживанию

Страница: 8 / 46

Cybex VR3 12050 Leg Extension Owner’s Manual
Safety
Page 1-2
Make sure that each machine is set up and operated on a solid level surface. • Do not install
equipment on an uneven surface.
Make sure that all users are properly trained on how to use the equipment. •
Make sure there is enough room for safe access and operation of the equipment. •
Perform regular maintenance checks on the equipment. Also pay close attention to all areas most •
susceptible to wear, including (but not limited to) cables, pulleys, belts and grips.
Immediately replace worn or damaged components. If unable to immediately replace worn or •
damaged components then remove from service until the repair is made.
Use only Cybex supplied components to maintain/repair the equipment. •
Keep a repair log of all maintenance activities. •
Inspect all cables and belts and connections prior to use. • DO NOT use if any components are worn,
frayed or damaged.
NOTE: It is the sole responsibility of the user/owner or facility operator to ensure that regular
maintenance is performed.
Safety Guidelines And Practices
Cybex recommends that all fi tness equipment be used in a supervised area. It is recommended that the
equipment be located in an access controlled area. Control is the responsibility of the owner. The extent
of control is at the discretion of the owner.
It is the responsibility of the purchaser/user of Cybex products to read and understand the owner’s
manual, and warning labels; as well as instruct all individuals, whether end users or supervising
personnel, on proper usage of the equipment.
PROPER USAGE:
Use machine only as described in the manual. Failing to follow proper instructions may result in injury.
Do Not Lean Against or Pull On the framework, weight stack, or any component, whether machine is at
rest or in use. Inappropriate or improper use may result in injury to users or third parties (bystanders).
Do not use machine if it is not located on a solid level surface or is improperly installed.
Provide an adequate safety perimeter between the machine, walls and other equipment to ensure that
the facility has the proper clearance for usage and training.
SECURING EQUIPMENT:
The machine has holes in the feet, which allow for ease in anchoring to the fl oor. Cybex strongly
recommends that, to eliminate rocking, tipping or falling over due to incorrect usage and misuse,
equipment be secured to a solid, level surface.
1. The solid, level surface should not deviate more than 1/8” over a 10’ distance or as defi ned and
required by local building and architectural codes.
2. Anchoring of equipment must be completed by a qualifi ed licensed contractor.