CYBEX Arc Trainer 425A, Руководство по обслуживанию

Страница: 67 / 78

Figure 8
Screws
(4)
Lower Left
Side Cover
11. Route the coax and power cable.
A.
Using a side cutter, cut the three cable ties.
See Figure 10.
Cable Tie
Drive frame assembly not shown.
45”
Figure 10
Access
Hole
B.
Remove both lower side covers.
10. Remove the display console.
A.
Using a 5/32” Allen wrench, remove the four
BHSCS with lock washers securing the display
console to the console mount. See Figure 9.
Figure 9
Display
Console
Lockwasher
(4)
BHSCS
(4)
Console
Mount
Console and
Heart Rate
Cables
BHSCS
(3)
B.
Disconnect the console and heart rate cables
from the display console. See Figure 9.
C.
Using a 7/32” Allen wrench remove the three
BHSCS securing the console mount to the
frame. See Figure 9.
B.
Locate the coax and power cable (F).
C.
Tape the ends of the coax and power cable
together (making it easier to guide the cables
down the frame).
D.
Measure out 45” of cable from top of frame as
shown in Figure 10.
E.
Route the cable inside top of frame as shown
in Figure 10.
F.
Pull rest of cable through the access hole.
See Figure 10.
G.
Attach three cable ties (P) replacing the ones
removed in step 11A. See Figure 10.
NOTE: Leave cable ties loose for cable
adjustment, they will be tightened later.
12. Remove covers from console.
A.
Using a Phillips screwdriver, remove the one
screw securing the console battery door
cover, then remove the four screws securing
the the rear console cover to the front
console cover. See Figure 12.
NOTE: The Power Cable (F) has a male and female
connector at either end. Make sure the female
end goes to the Monitor (AA) and the male end
is at the base. See Figure 11.
Figure 11
Male
Connector
Female
Connector
Coax Cable and
Power Cable with
male connector