User's Guide
BEFORE FITTING YOUR CVBERVISION PPC
Attention!
Before starting with the installation of the CyberVision PPC you should by
all means read this manual, otherwise the board or the computer could
suffer damage. Please also refer to our warranty conditions in respect to
unadequate handling and unauthorized repair.
The CyberVision PPC graphics card fits into a special expansion slot, on your CYBERSTORM
MKIII or CYBERSTROM PPC accelerator board.
Installation of the CyberVision PPC graphics card is simple to do and requires no technical
knowledge, but if you prefer, your dealer can install it for a small charge.
Advice!
The following installation instruction refer to installing a CyberVision PPC
graphics card into an Amiga 3000, 4000 or 4000 Tower. If the card is to be
fitted to a different compatible system please refer to the computer's
manual for instructions on opening the computer's case and for the
position of the CYBERSTORM MKIII/PPC accelerator boards in this
systems.
INSTALLING THE CYBERVISION PPC GRAPHICS CARD
1.
Switch your computer off.
2.
Disconnect all cables from your computer (monitor, mouse, keyboard, other interfaces,
etc.)
3.
Remove the screws that secure the casing cover. On the A3000 there are two at the
bottom of each side of the casing and one in the middle on the back. On the Amiga
4000 there are only two screws that secure the casing cover, on the back of the casing
on the right and left. If the card is to be fitted to a different compatible system please
refer to the computer's manual for instructions on opening the computer's case.
4.
Carefully remove the casing cover. On the Amiga 4000 you simply lift it off and on the
page 24