CyberResearch MPE 06, Руководство пользователя

Страница: 52 / 98

MPE Series
CyberResearch
®
Displays
52 ©Copyright 2011 CyberResearch, Inc.
used to power the monitor. Refer to Chapter
34
4 for the appropriate jumper settings of each
Control board.
NOTE:
The default voltage select jumper is configured for a 12V power source.
Do not change the jumper setting unless a 9~36V DC power connector is present
on the rear panel and is to be used as the monitor’s power source.
To properly set the voltage select jumper, the following steps must be completed:
Step 1: Use a screwdriver to remove all the screws holding the rear panel to the monitor.
Step 2: Remove the rear panel.
Step 3: Locate the voltage select jumper. (See Chapter
534
4 .)
Step 4: Use the jumper(s) to set the correct voltage input. (See Chapter
44
4 .)
Step 5: Replace the rear panel.
Step 6: Replace all removed screws. Step 0:
5.4 Connectors
Chapter
4
4 lists the rear panel connectors for the MPE series LCD monitors.
MPE 06 MPE 08 MPE 10 MPE 12
VGA Yes Yes Yes Yes
DVI-D - - - Yes
Power (12V Jack) Yes Yes Yes Yes
RS-232 Touch
Panel
- - Yes Yes
USB Touch Panel Yes - Yes Yes
Power (9~36V) - Yes Yes Yes