CyberPower CS150U48V3 Скачать руководство пользователя страница 5

© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners.

Page:  4 of 17

2.2 Battery Warnings

• Danger of explosion if battery is incorrectly connected or replaced.
• Worn-out or damaged batteries are considered environmentally unsafe. Always recycle used 

batteries or dispose of the batteries in accordance with all federal, state and local regulations.

• Do not open or mutilate batteries. Any gel or liquid emissions from the sealed lead-acid (SLA) 

battery contain sulfuric acid, which is harmful to the skin and eyes. Emissions are electrically 
conductive and corrosive.

• Batteries may produce explosive gases. Keep all open flames and sparks away from batteries.
• Batteries contain or emit chemicals known to the State of California to cause cancer and birth 

defects or other reproductive harm. Battery post terminals and related accessories contain lead 
and lead compounds. Wash hands after handling (California Proposition 65).

• Risk of Energy Hazard -12V max. / 7.2 (7) Ampere-Hour battery.  Before replacing batteries, 

remove conductive jewelry such as chains, wrist watches, and rings.  High energy through 
conductive materials could cause severe burns. 

• Wear protective clothing and eye protection whenever installing, maintaining, servicing, or 

replacing batteries.

• If any battery emission contacts the skin, immediately and thoroughly wash with water. Follow 

approved chemical exposure procedures.

• Neutralize any spilled battery emission with the special solution contained in an approved spill kit 

or with a solution of one pound Bicarbonate of soda to one gallon of water. Report chemical spills 
and seek medical attention if necessary.

• Never use un-insulated tools or other conductive materials when installing, maintaining, servicing 

or replacing batteries.

• A battery showing signs of cracking, leaking, or swelling should be replaced immediately with a 

battery of identical type and rating.

• The battery can energize hazardous live parts inside even when the AC input power is 

disconnected.

2.3  Limited Warranty

CyberPower warrants to you, the Initial Purchaser, that the Product will be free from defects in 
material and workmanship for three years from the date of original purchase, subject to the terms of 
this Limited Warranty. This Limited Warranty gives you specific rights, and you may have other 
rights, which vary from State to State or Province to Province.

Any Implied Warranty of Merchantability or for Fitness for a Particular Purpose, if applicable to the 
Product, is limited in duration to three years. This provision shall NOT create any Implied Warranty 
or Merchantability or of Fitness for a Particular Purpose that would not otherwise apply to the 
Product. NOTE: Some States and Provinces do not allow limitations on how long an implied 
warranty lasts, so the above limitation may not apply to you.

To be covered you must still be the owner of the Product at the time of the failure that results in the 
claim made under this Limited Warranty. Your sole and exclusive remedies are those provided by 
this Limited Warranty. This exclusion of other express warranties applies to written and oral express 
warranties. CyberPower excludes any liability for personal injury. CyberPower excludes any liability 
for direct, indirect, special, incidental, or consequential damages, whether for damage to or loss of 
property, loss of profits, business interruption, information or data. This exclusion applies even 
though damage or loss is caused by negligence or other fault. NOTE: Some States or Provinces do 
not allow the exclusion or limitation of incidental or consequential damages, so the above limitation 
may not apply to you.

Содержание CS150U48V3



















Отзывы: