CyberData V3 Keypad, Руководство по эксплуатации, Страница: 19 / 65

Setting Up the V3 Paging Server
Connecting the V3 Paging Server
CyberData Corporation 930427B Operations Guide
11
2.3.7 Restore the Factory Default Settings
The V3 Paging Server is delivered with factory set default values for the parameters in Table 2-3 . Use
the
RTFM
switch (see Figure 2-9 ) on the back of the unit to restore these parameters to the factory
default settings.
Figure 2-9. RTFM Switch
Note When you perform this procedure, the factory default settings are restored. The default
parameters for access are shown in
Table 2-3 .
To restore these parameters to the factory default settings:
1. Press and hold the
RTFM
switch until the status and paging lights come on.
2. Continue to press the switch until after the indicator lights go off, and then release it.
3. The V3 Paging Server settings are restored to the factory defaults.
Table 2-3. Factory Default Settings
Parameter Factory Default Setting
IP Addressing DHCP
IP Address
a
a. Default if there is not a DHCP server present.
10.10.10.10
Web Access Username admin
Web Access Password admin
Subnet Mask
a
255.0.0.0
Default Gateway
a
10.0.0.1
RTFM Switch