Operations Guide
930500I
CyberData Corporation
28
Installing the VoIP V3 Indoor Intercom
Configure the SIP Parameters
2. On the
SIP Configuration
page, enter values for the parameters indicated in
Table 2-9
.
Table 2-9. SIP Configuration Parameters
Web Page Item
Description
Enable SIP Operation
Enables or disables SIP operation.
SIP Settings
Primary SIP Server
Use this field to set the address (in dotted decimal notation or
as a canonical name) for the Primary SIP Server. This field
can accept canonical names of up to 255 characters in length.
Primary SIP User ID
Type the
SIP User ID
for the Primary SIP Server
(up to 64 alphanumeric characters).
Primary Auth ID
Type the
Authenticate ID
for the Primary SIP Server
(up to 64 alphanumeric characters).
Primary Auth Password
Type the
Authenticate Password
for the Primary SIP Server
(up to 64 alphanumeric characters).
Backup SIP Server 1
Backup SIP Server 2
• If all of the
Primary SIP Server
and
Backup SIP Server
fields are populated, the device will attempt to stay registered
with all three servers all of the time. You can leave the
Backup SIP Server 1
and
Backup SIP Server 2
fields blank
if they are not needed.
• In the event of a registration failure on the
Primary SIP
Server
, the device will use the next highest priority server for
outbound calls (
Backup SIP Server 1
). If
Backup SIP
Server 1
fails, the device will use
Backup SIP Server 2
.
• If a higher priority SIP Server comes back online, the device
will switch back to this server.
Backup SIP User ID 1
Backup SIP User ID 2
Type the
SIP User ID
for the Backup SIP Server
(up to 64 alphanumeric characters).
Backup SIP Auth ID 1
Backup SIP Auth ID 2
Type the
SIP Authenticate ID
for the Backup SIP Server
(up to 64 alphanumeric characters).
Backup SIP Auth Password 1
Backup SIP Auth Password 2
Type the
SIP Authenticate Password
for the Backup SIP
Server (up to 64 alphanumeric characters).
Use Cisco SRST
When selected, the backup servers are handled according to
Cisco SRST (Survivable Remote Site Telephony).
Remote SIP Port
Type the
Remote SIP Port
number (default 5060)
(8 character limit).
Local SIP Port*
Type the
Local SIP Port
number (default 5060)
(8 character limit).
Outbound Proxy
Type the Outbound Proxy as either a numeric IP address in
dotted decimal notation or the fully qualified host name
(255 character limit [FQDN]).
Outbound Proxy Port
Type the Outbound Proxy Port number (8 character limit).
Register with a SIP Server
Check this box to enable SIP Registration.
For information about Point-to-Point Configuration, see
Section 2.4.6.2, "Point-to-Point Configuration"
.
Re-registration Interval (in seconds)
Type the SIP Registration lease time (in seconds)
