Cyberbank TRITON CB-0880NP, Руководство пользователя

Страница: 106 / 193

G
Chapter 7 Using the Mobile Phone 7-5
Using the SEND button
You can make a call as follows :
z
Enter phone number and tap the SEND button to make a call.
z
When you tap the SEND button shortly once, the number you last called
appears on the screen and if you tap this button once more, you are connected
to this number.
z
You can use the up/down control to have the recently dialed numbers displayed.
When you press the up button or down button of the up/down control, the
number you last called appears on the screen. If you press the Enter button,
you are connected to this number.
Using the CLEAR button
If a mistake is made while dialing, tap the Clear button to clear the last digit, or tap and
hold the Clear button to clear all the digits.
Using the END button
Tap the END button to end a call.
Tap and hold the END button for a little longer (2 or 3 seconds) to turn the CDMA
module off so that you cannot make a call, send SMS messages and browse the Internet.
Tap and hold the END button again for a little longer (2 or 3 seconds) to turn the CDMA
module on.
Using the Vibrate mode
Tap and hold the icon on the dial pad to turn the Vibrate mode on. Then you will be
able to feel vibrating on your device and also see the icon on the Phone status pane.
On this Vibrate mode, you will feel the vibration on your device when a call is coming.
Using the Lock button
Tap and hold the icon on the dial pad to turn the Lock mode on. Then you will be
able to see the icon on the Phone status pane. You cannot make any calls on the
Lock mode. When you want to get out of the Lock mode temporarily, enter the password
on your dial pad. Turn your phone program off and on to go back to the Lock mode. If
you want to get out of the Lock mode permanently (in stead of temporarily), tap and hold
the Lock button to have the password screen displayed. Then enter the password that is
set as “0000”.
You can not make a call, browse the Internet and send SMS messages while the
CDMA module is not on.