5.9 Pairing When Only Remote Transmitter Has Been Lost
To pair a replacement remote transmitter when the only transmitter has been lost, remove the cap
on the SolarSmart Plus side with the smaller cap as shown in Fig. 15 and follow the steps below:
1.
DISCONNECT
the battery for
3 seconds
.
2.
CONNECT
the battery for
3 seconds
.
3.
DISCONNECT
the battery for
3 seconds
.
4.
CONNECT
the battery for
3 seconds
.
5.
WAIT
for
3 seconds
.
6. Press the
STOP
button on the new transmitter (the motor will now rattle curtain).
7. Within 2 seconds press the
UP
button on the new transmitter (the motor will rattle curtain again).
The replacement remote transmitter is now paired to the receiver.
NOTE Remember to remove all other remote transmitters EXCEPT the replacement transmitter
after pairing. This will improve your security if the old transmitter was lost or stolen.
COVER THE SOLAR PANEL WITH A CLOTH
Fig. 15
6) Positioning The SolarSmart Plus Unit
NOTE For correct operation and optimum performance of SolarSmart Plus, the following
installation and positioning instructions MUST be followed.
6.1 SolarSmart Plus Optimum Performance Position
The SolarSmart Plus unit is best positioned facing North and in direct sunlight.
North
Summer
Winter
East
West
5.6 Removing A Remote Transmitter
If a remote transmitter needs to be removed from the memory of the receiver, follow the steps shown in Fig. 12.
The remote transmitter is now removed from the memory of the receiver.
Fig. 12
STOP
HOLD FOR
5 SEC
MOTOR WILL
RATTLE THE
CURTAIN
UP
MOTOR WILL
RATTLE THE
CURTAIN
DOWN
WITHIN 2 SEC AFTER RATTLE
WITHIN 2 SEC
5.7 Removing Multiple Remote Transmitters
If all but one of the remote transmitters need to be removed from the memory of the receiver
OR
if all transmitters need to be removed from the memory and a new transmitter needs to be added,
follow the steps shown in Fig. 13. This will remove all transmitters from the memory except for the remote transmitter being used in the process.
All transmitters, EXCEPT the one being used are now removed from the memory of the receiver.
Fig. 13
STOP
HOLD FOR
5 SEC
STOP
HOLD FOR
5 SEC
MOTOR WILL
RATTLE THE
CURTAIN
UP
MOTOR WILL
RATTLE THE
CURTAIN
DOWN
WITH EXISTING OR ANOTHER TRANSMITTER
WITHIN 2 SEC
WITHIN 2 SEC AFTER RATTLE
WITHIN 2 SEC
5.8 Removing The Last Remote Transmitter
If the last remote transmitter needs to be removed from the memory of the receiver, follow the steps shown in Fig. 14.
All remote transmitters are now removed from the memory of the receiver.
Fig. 14
STOP
HOLD FOR
5 SEC
STOP
HOLD FOR
5 SEC
MOTOR WILL
RATTLE THE
CURTAIN
UP
MOTOR WILL
RATTLE THE
CURTAIN
UP
WITHIN 2 SEC
WITHIN 2 SEC AFTER RATTLE
WITHIN 2 SEC
Page 3