8.
Remove unit from cabinet.
9.
Using a 1/8’’drill bit,
drill marked locations for
screw holes in the base of
the cabinet.
10.
Drill a 2 ½’’ hole in the floor of the
cabinet approximately the same distance
off the side wall of the cabinet and directly
behind the unit. Use the
measurement you took
in Fig.7.
12.
On the toe kick of the cabinet, mark and
cut out a 6 ¾’’ long and a 3 ½’’ high slot.
13.
Attach low
voltage wire along
flex hose with wire
tie wraps (3)
provided.
15.
Attach flex hose
to spigot adapter and
fasten with hose clamp
provided.
14.
Feed flex hose
through hole drilled
in step # 10 through
slot in toe kick.
15a.
Attach universal 90 degree elbow to
vacpan.
15b.
Strip wire ends and connect the low
voltage wire to the vacpan using the
terminals marked
“low voltage only”.
11.
Vacpan requires a minimum of 3 ½’’
toe kick height.
5
Note:
The vacpan can be installed in the toe kick
of the cabinet without using the trim plate,
by gaining access through the cabinet floor.
Do Not cut slot for vacpan until
reviewing page 6 for details!
