6
9. Tighten clamp lever.
10. If oversize or undersize threads are required, set the index line in direction of OVER or
UNDER size mark on size bar.
Threading Operation
Relevant parts
’ name, please refer to the photos within this manual.
1. Install die set. Refer to dies Installation procedure above.
2. Swing cutter and reamer to UP position.
3. Swing die head to DOWN position with throwout lever set
to CLOSE position.
4. Switch on the threader. Oil should flow from die head.
5. Turn carriage handwheel to bring dies against end of pipe.
Exert pressure on handwheel to start dies.
6. When die head end of pipe contacts trigger, throwout lever
is automatically opened on tapered threads.
7. Switch off power and turn carriage handwheel to back die
head off. Swing the die head to UP position.
Pipe cutting
Relevant parts
’ name, please refer to the photos within this manual.
1. Swing reamer and die head to UP position.
2. Move pipe cutter DOWN onto pipe and move carriage with
handwheel to line up cutter wheel with mark on pipe.
3. Tighten cutter feed screw handle on pipe keeping wheel
aligned with the pipe.
4
. Grasp the pipe cutter’s feedscrew handle with both hands
(Figure 4).
5. Switch on the machine.
6. Tighten the feedscrew handle slowly and continuously until
the pipe is cut. Do not force the cutter into the pipe.
7. Switch off the machine. Swing pipe cutter back to the UP
position.
Pipe Reaming
Relevant parts
’ name, please refer to the photos within this
manual.
1. Move reamer arm into DOWN position.
2. Switch on the machine. Advance reamer into pipe and
complete reaming by exerting pressure on handwheel
(Figure 5).
NOTE! Do not apply excessive pressure on handwheel.
Fig 5
Fig 3
Fig 4
