COMPONENT
MAINTENANCE
Daily maintenance:
• check the filter and replace it if necessary.
• for the models with oil bath filter check the oil level (1)
• check tightness of tank cap and replace it if necessary (2)
• check fuel filter every 100 hours of operation and replace
it if necessary (6)
• check the oil level and top up if needed (3)
• first oil change after 20 hours of operation (3-4)
• check tightness monthly (5)
Air filter
Fuel tank
Engine
V-belts
3
2
1
6
5
4
6) MAINTENANCE, STORAGE,
DEMOLITION AND DISPOSAL
6.1) MAINTENANCE
5) STORAGE, LIFTING
AND TRANSPORT
5.1) WARNINGS
5.2) JOINT CUTTER LIFTING
5.3) TRANSPORT
The total weight of the machine varies according to the
model. Maximum weight 143 kg
ATTENTION!
Lifting, transport, installation and maintenance must be performed
by qualified technicians. Before handling the machine, make sure
that the forklift is suitable for supporting the load.
To avoid damage caused by incidental fall of the machine,
always make sure that people keep at a safe distance from
the forklift.
• Use the lifting hook to load and download the machine and use suitable means
of transport
• Do not use the joint cutter’s handles to lift the machine
• Make sure that the ramps used to load/unload the machine are properly fixed,
stable and suitable for bearing the weight of the machine
• When carrying the machine, fix it so as to prevent it from tilting over or sliding
about
• For very long transits, empty out the fuel tank completely
It is strongly recommended to use a forklift equipped with forks of at least 2 metres
length to lift and handle the machine. Make sure that the forks extend beyond the
opposite side.
• Maintenance and repair must be performed under the supervision of the person
appointed by the employer
• When maintenance is done the machine, the engine must be off
• Everyday check tension of V-belts. Replace belts if worn out (replace the whole set)
• Check the efficiency of the blade cooling system (tank, connectors, nozzles)
• Clean filters regularly
• Every 100 hours of operation inject grease into the greasing system of the wheel
support, blade shaft supports and hand-wheel support
• Every 100 hours of operation overhaul all components of the machine
• Drain fuel out completely at least once a year
• In case of inactivity for more than 48 hours, empty out the fuel tank completely
and eliminate condensation water
• In case of prolonged inactivity, additives must be added to the petrol to avoid
damage to the engine
MACHINE MAINTENANCE
ENGINE MAINTENANCE
6.2) STORAGE
In case of prolonged inactivity, store the joint cutter in a dry and sheltered place.
Temperatures below -10
°
C and above +60
°
C could cause serious damage to the
machine.
It is prohibited to place any material or
tools on the machine
6.3) DEMOLITION AND DISPOSAL
Dispose of consumption materials and materials deriving from demolition following
the regulations in force in the country where you are working.
(V-belts)
(belts tension
adjustament device)