CUTRA WC40000F25W, Инструкция по эксплуатации

Страница: 9 / 16

1. In order to transmit the ultrasonic waves, fix the product with the adequate
blade and blade fixture.
* Make sure that the blade and its fixture are correctly fixed.
2. The stain on the blade or on its fixture can cause heat, noise, and damage
of the product.
* Make sure the product is stainless, and change if there are any stain on
the blade or its fixture.
Product management
07
Blade fixture
Blade
Blade fixing screw
* About blade and blade fixture
When changing the blades
Insert the dead end of the blade that will be changed into the inside of
the blade fixture. Line up the holes of blade setscrew and the blade fixture.
When changing blade fixture
Line up the holes of the blade setscrew and the new blade fixture.
-
Be careful with the dead end of blade and the direction of blade.
-
Use the designated blades only.
-
When other than designated blades are used, the product might
not operate correctly and this can cause breakdown or fall out
of the blades.
-
When the blade is not correctly adjusted, a buzzer beeps and
the handle power button does not operate.
Cautions
Make sure that the blade and its fixture is correctly set, and tighten the
setscrew with a hexagonal wrench.
Lastly
Cautions
-
Tighten the setscrew of blade.
-
When the setscrew is not correctly adjusted, the blade can pop
out and this may cause accidents and cause of breakdown.
-
Change the hexagonal wrench when worn down.
-
Ask for the manufacturer's help when the setscrew does not fall
out.
-
When the blade has been changed while the vibrator produces heat,
the setscrew can loosen when the temperature goes down.
Make sure that the setscrew is correctly fixed before using the product.