Adjustable Bed Frame
The
“ELEVATION”
Installation Guide
STEP 1
.
For safety reasons, the following should be performed by 2 people.
Carefully lift the bed frame unit out of the shipping carton with the
top side facing downward.
STEP 2.
Assembling Bed Legs
Open the accessories box, take out the 4 legs, and thread them in a
clockwise direction into the threaded holes in the frame.
STEP 3
.
Remove and extend the power cord from the frame.
STEP 4
.
Take plastic wrapping off the base frame.
STEP 5
.
Carefully rotate the base frame over so the top side is facing upward.
Be careful not to rest the frame on its side. The weight may damage
the legs.
STEP 6
.
Plug the power cord into a grounded electrical outlet.
STEP 7
.
Install batteries in hand unit.
If the hand unit is a wired unit, no batteries are needed.
Try all functions on the hand control to
ensure all features are operational.
If the bed does not work, refer to Troubleshooting on p.14.
STEP 8
.
Return bed to flat or level position.
STEP 9.
Assembling
The Mattress Retainer Bracket
Fasten the mattress retainer bracket (
B
) to the front of the bed frame
using the retainer bolts (
F
) and 1/4 inch Retainer washers (
H
), as
shown in the diagram below.
4
TIGHTEN THE LEGS SECURELY TO THE FRAME.
DO NOT OVERTIGHTEN THE BED LEGS.
NOTE:
For optimal safety, a surge protector should be
used (not supplied with this Adjustable Bed).
NOTE :
Use
ONLY
the allen wrench to fasten the retainer
bolts.
DO NOT
use a power screwdriver as it may over tighten the
bolts. Mattress retainer hardware must
NOT
be over tightened.
If the adjustable frame is to be set up without a headboard,
simply install a mattress on the frame.Installation is now complete.
If a headboard is to be installed, proceed to step 10 on next page.
Important!
MAKE SURE POWER CORDS DO NOT OBSTRUCT
ANY ADJUSTABLE BED MECHANISMS.
