Bag D
Side Shocks
Step #2:
Following Figure #16, press (1) #1231
1/4" X 3/8" Flanged Bearing into each end of the
#8031 Standard Diff Hub. Slide the Hub onto the axle
and align the notch in the Hub into the Diff Ring. Next
place (1) #8034 Diff Thrust Cone onto the axle with
the taper facing the Hub. Then slide (3) #8034 Bell
Washers onto the axle with the taper pointing away
from the Thrust Cone. Secure the Diff Assembly to the
Axle using (1) #8036 8-32 Nylon Lock-Nut.
NOTE:
Do NOT overtighten the Diff Nut, just tighten it a half turn past when it is
tight to the Bell Washers. You will adjust the Diff Nut tighter once
the car is being driven.
Step #3:
Press (1) #1231 1/4" X 3/8" Flanged Bearing into each
Ride Height Adjuster with the 3 Dots on it. Place (1) #8040 Ride
Height Adjuster into each oval on the rear pod plates as shown in
Figure #17.
NOTE:
There are 4 different Ride Height Adjuster in the kit
marked by a number on the bottom of the part. Never mix and
match different sized Ride Height Adjusters, the axle should always slide thru both
bearings easily.
Step #4:
Slide the Axle thru the Bearings in the Ride Height Adjusters mounted in
the Rear Pod Plates. Following Figure # 18, slide (1) #8037 .050" Axle Spacer and
(2) #8038 .100" Axle Spacers onto the axle with the tapered end facing toward the
Spur Gear. Finally place the #8033 Clamping
Hub onto the axle and tighten so the screw is
just snug, over-tightening will just bend or
break the hub. There should be just a paper
width of play when the axle slides side to
side.
NOTE:
Left over in the bag is (8) 3/8" SH screws to be used to mount the Rear
Tires to the Axle Hubs.
For the following 7 steps, complete each step twice to make 2 shocks.
Step #1:
As shown in Figure #19, soak the #8103 VC foam with 20wt
Shock Oil and push it into the VC Housing.
Содержание Aggressor
Страница 15: ......
