Custom Works Aggressor, Руководство пользователя

Страница: 2 / 15

Bag A
Chassis
To begin building this kit locate the bag of graphite parts, start by lightly sanding the
edges of the graphite pieces using a medium grade sandpaper like 220 Grit or a
sanding drum on a Dremel. Run a thin bead of Super Glue around the edges to give
pieces greater durability and reduce the chance of splitting the chassis in a hard
wreck. To smooth the edges of the battery slots you may use a file or an appropriate
pointed sanding stone on a Dremel.
Step #1: Attach the #8010 Front Bumper to the #8000
Chassis using (2) 3/8" FH Screws thru the bottom of the
Chassis with (2) #5212 Washers and (2) 4-40 Lock-nuts as
shown in Figure #1.
Step #2: Attach each #8071 Front Track Plates to the
main chassis using (1) 3/8" FH Screw thru the bottom of
the Chassis and (1) 4-40 Lock-nut. Notice that the screw
passes thru the Chassis in the 3rd hole from the top of
the Chassis in the row of holes and then thru the 2nd
hole from the top of the 5 holes on the Front Track Plate
as shown in Figure #2.
Step #3: Using (2) 1/2" BH Screws mount (1) #8018 Center Shock
Tower on each side of the #8023 Center Shock Anchor and fasten with
(2) 4-40 Lock-nuts. Notice the antenna mount hole in the Anchor and
the holes in the Shock Tower face away from each other. Mount the
Center Shock Tower to the Chassis with (2) 3/8" FH Screws thru the
holes shown in Figure #3.
Step #4: Mount the (2) #8022 Anchor Plates to the Chassis
using (4)1/4" FH Screws as shown in Figure #4.
Step #5: Attach the #8012 Shock Tower to the Anchor Plates
using (2) 1/4" BH Screws. Notice that side with the furthest
distance between the shock
mounting holes and the shock tower
mounting holes is on the left side of
the car as shown in Figure #5. Now
mount (2) #8121 Ball Studs thru the
top most holes in the shock tower
and the balls facing the front of the
car using (2) 4-40 Lock-nuts.