Custom Works Aggressor, Руководство пользователя

Страница: 1 / 15

REQUIRED READING
Thank You and Congratulations on purchasing this Aggressor ! Within this kit you will find a
race winning car with over 17 years worth of CUSTOM WORKS design and quality. In order
for you to realize this race car’s winning potential it is important to follow the written text
along with the pictures included. The steps required to build this car are very easy, as long
as you read before you build.
The instructional format for building this car is to open each bag in alphabetical
order. Each bag of parts will be broken down into “Steps” in the manual. All parts
and hardware needed to complete all steps for each separate bag, will be found in
each individual bag. There is no need to steal screws from other bags. In the rare
event you need to look in a different bag for a certain part, it will be noted clearly.
All hardware (screws, washers, nuts, etc…) are referred to by size and type in the
instructions. To help clarify which screw or nut the instruction is calling for refer to the
HARDWARE REFERENCE supplement. The size of the screw or nut should match the
“shadow” of the same piece very closely.
Screw ID’s are: FH =Flat Head BH =Button Head SH =Socket Head SS =Set Screw
Do NOT use power screwdrivers to drive screws into parts. The fast rotation speed can easily
melt and strip plastic parts or cross-thread into the aluminum parts.
REQUIRED TOOLS
Double Sided Tape .110" Drill Bit Super Glue
Hobby Scissors X-Acto Knife 220 Grit Sandpaper
Small Needle Nose Pliers Phillips Head Screw Driver 400 Grit Sandpaper
3/16" Wrench Blue Loctite #43 Drill Bit