Custom Crimp CC4-50, Руководство оператора

Страница: 5 / 17

5 Page
DIE SET UP AND INSTALLATION
Industrial and Hydraulic hose dies are available for this crimper.
Industrial Dies are inserted directly into the Master Dies and
hydraulic dies require an intermediate die. Hydraulic Dies are
available with an 80mm, 84mm, 99mm and 130mm O.D.
The I.D. of the intermediate die must match the O.D. of the
hydraulic die or accurate crimps are not possible.
INDUSTRIAL DIE INSTALLATION
INTERMEDIATE ADAPTER DIE INSTALLATION
Turn on the crimper at the master power switch (See AccuCrimp
Controller Instructions) and go to Manual mode.
Insert the die removal tool in the release hole to release the
retaining spring and attach either an Intermediate Adapter Die or a
Hydraulic Die to the Master Die. the numbers stamped on the face
of the die should face the operator.
Mount all 8 dies in a similar manner.
If Industrial Dies are being used, proceed to the AccuCrimp
Operating instructions and set up the crimper for the correct crimp
diameter.
If Hydraulic Dies are being used, see Hydraulic Die Installation
instructions.