Custom Audio Electronics Plus II, Руководство пользователя

Страница: 21 / 64

HEXADECIMAL DUMP
12345678
90123456
789uisdf
hkjsdhfh
sdfkjhsd
fsdfkhjw
eioyuwqe
oriuweri
ouweriou
weriouwe
riouwerh
klsdfhks
dfksdfhj
sdfkj
≥
sd
fk
≥
jshdf
jklh
31 32 33 34 35 36 37 38
39 30 31 32 33 34 35 36
37 38 39 75 69 73 64 66
68 6B 6A 73 64 68 66 68
73 64 66 6B 6A 68 73 64
66 73 64 66 6B 68 6A 77
65 69 6F 79 75 77 71 65
6F 72 69 75 77 65 72 69
6F 75 77 65 72 69 6F 75
77 65 72 69 6F 75 77 65
72 69 6F 75 77 65 72 68
6B 6C 73 64 66 68 6B 73
64 66 6B 73 64 66 68 6A
73 64 66 6B 6A F2 73 64
66 6B F2 6A 73 68 64 66
6A 6B 6C 68
1.7 CONFIGURATION
This printer permits the confi guration of default parameters. The printer’s confi gurable parameters are:
Printer Interface (1) : Centronics, TTL.
Baud Rate (2) : 38400, 19200 D , 9600, 4800, 2400,1200, 600.
Data Length (2) : 7, 8 D bits/chr.
Parity (2) : None D , Even or Odd.
Handschaking (2) : XON/XOFF D o Hardware.
Autofeed: CR disabled D o CR enabled.
Columns: 24 col. D , 40 col. e 42 col.
Print Mode: Normal D o Reverse.
Char Mode: Normal D , Double width (2 x Width), Double height (2 x Height), Expanded.
Print Density: -2, -1, 0 D , +1, +2.
GENERAL NOTES: The parameters marked with the symbol
D
are the default values.
(1)
NOTE: Only parallel interface model parameter.
(2) NOTE: Only serial interface model parameter.
The settings made are stored in nonvolatile memory and are loaded automatically.
During power-up, if the FEED key is held down, the printer enters the autotest routine and prints out the setup
report. The printer will remain in standby in Hexadecimal dump mode
(see par. 1.8) until another key is pressed
or characters are received through the printer communication port.
When the FEED key is pressed, the printer enters parameter confi guration. Each time the FEED key is pressed,
the parameter will change and the current value will be printed out. Once the desired value has been attained,
hold the FEED key down for at least a second to pass to the next parameter, and so on. Printing out of a new
printer set up report indicates that set up is complete.
1.8 HEXADECIMAL DUMP
This function is used to display the characters received
from the communications port; after the reception of each
8 characters from the communications port, the printer
prints out both the hexadecimal code received as well as
the corresponding ASCII code.
Shown below is an example of a Hexadecimal Dump:
(Fig.1.12)
1. INSTALLATION AND USE
User Manual
PLUS II 1-11