Custom Audio Electronics KPM302III, Руководство пользователя

Страница: 99 / 188

PRINTHEAD TEST
POWERON Setting of the performing of the print head test:
Disabled D = the test is performed only during the printing of the setup report
Enabled = the test is performed at each power on
FONT TYPE Setting of the font type:
International D = enables the use of the 256 characters font tables
Chinese GB18030 = enables the use of the chinese extended font GB18030
Korean CP949 = enables the use of the korean font CP949
CODE PAGE
Identiier number of the character code page to use.
See paragraph 9.12
to learn about the character tables corresponding to the identiication
numbers set with this parameter.
The character tables set with this parameter are the same set with the command 0x1B
0x74 (refer to the commands manual of the device).
The numeric value of the identiier is made up with the following two parameters for the
setting of two digits for the tens and the units:
CODE PAGE [num x 10]
Setting the digit for tens:
0
D
2 4
1 3 5
CODE PAGE [num x 1]
Setting the digit for units:
0
D
2 4 6 8
1 3 5 7 9
3F PAPER END
MANAGEMENT KPM302III TF, KPM302III TF-EJ, KPM302III TF-vSEL, KPM302III TF-hSEL
TK302III TF
Management of the paper end sensors of triple feeder:
Print All
D
= when the paper end sensor of a feed line of the triple feeder detects the
paper end, it is not possible to change the feed line until all tickets remain-
ing in that feed line are printed (so that the paper sensors of the printer will
have detected the end of paper)
Eject = when the paper end sensor of a feed line of the triple feeder detects the
paper end, the device automatically ejects the paper remaining on that feed
line and prints diagonal voiding lines on the remaining tickets
Retract = when the paper end sensor of a feed line of the triple feeder detects the
paper end, the device performs a paper retracting up to the parking position
99