Custom Audio Electronics KPM180H, Руководство пользователя

Страница: 86 / 152

7.1 Enable alignment
The device is provided with the two following sensors for alignment (see igure):
•
SENSOR 1, a mobile sensor placed on the lower lat,
•
SENSOR 2, a mobile sensor placed on the upper lat.
SENSOR 1
SENSOR 2
lower flat
upper flat
To guarantee the alignment, it is necessary to correctly choose the sensor to use for the black mark detection depending
on the type of black mark and its location on the ticket.
To do this, you must enable the parameter “Black mark position” during the setup procedure (see
chapter 6 ) and set the
correct value of this parameter as described in the following table.
SENSOR
USED
VALUE OF THE
“BLACK MARK POSITION”
PARAMETER
USING MODE
OF SENSORS
BLACK MARK TYPE
- Disabled - Alignment disabled
1 Bottom
Relection
Black mark printed on the non-thermal side of paper
2 Top
Relection
Black mark printed on the thermal side of paper
1 + 2 Transparent Transparence Hole between tickets
86