B
MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
69
Owner’s Guide
TROUBLESHOOTING
The troubleshooting chart lists basic problems that can occur during start and operation of the vehicle. For complete
information about the hydraulic and electrical systems, contact your Cushman Dealer.
Controller Area Network (CAN) Bus Connector Locations
The diesel engine has a three pin vehicle CAN bus connector located to the left of the fuse/relay panel.
The gasoline engine is monitored and controlled by the engine controller located on the right side of the engine. The two
CAN bus connectors are located to the left side of the fuse/relay panel. The four-pin connector is for the Kubota Engine
Controller (ECU) CAN bus connector. The three-pin connector is for the vehicle’s CAN bus connector. A second four-pin
ECU CAN bus controller is located above the gasoline engine controller.
NOTICE: For factory help or replacement of the Kubota Engine Controller, provide the engine model and serial
number located on a plate on the rear corner of the engine valve cover.
Symptoms
Possible Causes
Action
Engine will not
start.
1.
Clutch pedal not pressed.
1.
Check Interlock System and start-up procedure.
2.
Glow plug has not timed
out. (Diesel Engine Option)
2.
Reset ignition switch and allow glow plug to time out
before cranking engine.
3.
Battery low on charge or
defective.
3.
Inspect condition of battery and battery connections.
4.
Fuel tank empty or dirty.
4.
Fill with fresh fuel. Change fuel filter. Bleed fuel lines.
5.
Fuse blown.
5.
Replace fuse.
6.
Relay(s) defective.
6.
Test and replace relay.
Engine hard to
start or runs
poorly.
1.
Fuel level low, fuel or fuel
filter dirty.
1.
Fill with fresh fuel. Change fuel filter. Bleed fuel lines.
2.
Air cleaner dirty.
2.
Inspect and replace air filter.
3.
Injectors, fuel pump.
3.
Consult engine manual.
4.
Engine problem.
4.
Consult engine manual.
Engine stops.
1.
Fuel tank empty.
1.
Fill with fresh fuel and bleed fuel lines.
Engine
overheating.
1.
Coolant level low.
1.
Inspect and add coolant.
2.
Air intake restricted.
2.
Clean air intake at radiator.
3.
Water pump belt broken or
loose.
3.
Tighten or replace belt. See engine manual.
Battery not
holding charge.
Battery light on.
1.
Loose or corroded battery
terminals.
1.
Inspect and clean terminals.
2.
Low electrolyte.
2.
Refill to correct level.
3.
Alternator belt loose or
broken.
3.
Tighten or replace belt. See engine manual.
4.
Charging system defective.
4.
See engine manual.
ECU CAN Bus Connector
Vehicle CAN Bus Connector
Содержание Truckster XD 2018
Страница 1: ...OWNER S GUIDE 672240 A Truckster XD ISSUED JANUARY 2018 Distributed by...
Страница 6: ......
