Cushman Titan 36V, Руководство пользователя и руководство по обслуживанию

Страница: 28 / 72

OPERATION AND SERVICE INFORMATION
Page 10
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
inflation could cause the tire to separate from the wheel
or cause the tire to explode.
Tire inflation should be determined by the condition of the
terrain. See GENERAL SPECIFICATIONS section for
recommended tire inflation pressure. For outdoor appli-
cations with major use on grassy areas, the following
should be considered. On hard turf, it is desirable to have
a
slightly higher inflation pressure. On very soft turf, a
lower pressure reduces the possibility of tires cutting into
the turf. For vehicles being used on paved or hard sur-
faces, tire inflation pressure should be in the higher
allowable range, but under no condition should inflation
pressure be higher than recommended on tire sidewall.
All four tires should have the same pressure for opti-
mum handling characteristics. Be sure to install the valve
dust cap after checking or inflating.
The vehicle is fitted with low pressure tubeless tires
mounted on one piece rims; therefore, the most cost
effective way to repair a puncture in the tread is to use a
commercial tire plug.
Tire plug tools and plugs are available at most automotive parts
outlets and have the advantage of not requiring the tire be
removed from the wheel.
If the tire is flat, remove the wheel and inflate the tire to
the maximum recommended pressure for the tire.
Immerse the tire in water to locate the leak and mark with
chalk. Insert tire plug in accordance with manufacturer’s
instructions.
To reduce the possibility of severe injury, be
s u r e m o u n t i n g / d e m o u n t i n g m a c h i n e i s
anchored to floor. Wear OSHA approved safety
equipment when mounting/demounting tires.
If the tire is to be removed or mounted, the tire changing
machine manufacturer’s recommendations must be fol-
lowed in order to reduce possibility of severe injury.
Wheel Installation
To reduce the possibility of component damage, do not
tighten lug nuts to more than 85 ft. lbs. (115 Nm) torque.
It is important to follow the ‘cross sequence’ pattern when
installing lug nuts. This will assure even seating of the wheel
against the hub.
With the valve stem to the outside, mount the wheel onto
the hub with lug nuts. Finger tighten lug nuts in a ‘cross
sequence’ pattern (Ref Fig. 9 on page 10). Tighten lug
nuts to 50 - 85 ft. lbs. (70 - 115 Nm) torque in 20 ft. lbs.
(30 Nm) increments following the ‘cross sequence’ pat-
tern.
Fig. 9 Wheel Installation
LIGHT BULB REPLACEMENT
Fig. 10 Headlight, Turn Signal & Marker Light Bulb
Replacement
For vehicles with headlights (Ref Fig. 10 on page 10),
Remove the two screws on rear of the headlight.
Remove screws, pull headlight out and disconnect wires.
Connect wires to new headlight. Installation is the
reverse of dissasesembly.
To replace the turn signal light bulb, remove connector
from rear of bulb and lens. Unsnap bulb and lens from
housing. Install new bulb and lens by snapping into hous-
ing. Install connector.
'Cross Sequence'
1
2 5
3 4
Tire/wheel style
may vary
Ref Whi 7
Bulb
Bulb
Headlight
Housing
Turn Signal
Housing Turn Signal
Connector
Ref Hdr 5