Cushman Hauler 800XE, Руководство пользователя

Страница: 24 / 64

B
16
OPERATING PROCEDURES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Owner’s Guide
Explosive hydrogen gas is created during the charge cycle of the batteries. Good ventilation is necessary to remove gas
from closed spaces. The air must change every 12 minutes.
Never charge a vehicle near flammable materials, open flame or sparks. Never charge a vehicle near gas water heaters
and furnaces.
Before a new vehicle is put into operation, complete the items shown in the INITIAL SERVICE CHART .
PORTABLE CHARGER INSTALLATION
Risk of electric shock. Connect the charger power cord to an outlet that is correctly
installed and connected to an electrical ground according to all codes and regulations. A
grounded outlet is necessary to decrease the risk of electric shock – do not use ground
adapters or replace the plug. Do not touch parts of output connector or battery terminals
that do not have insulation.
Disconnect the DC plug before you make or break the connections to a battery that is
charging. Do not open or disassemble the charger. Do not operate the charger if the AC
cord is damaged. Make sure qualified personnel does all repair work to the charger.
Do not allow children to use the charger.
To prevent over-heating that can cause damage to the charger and possible fire, keep the air fins
clear. Install portable chargers on a platform above the ground to allow maximum air flow around
and below the charger.
Use the charger on 48-volt battery systems. Other use can cause personal injury and damage.
Lead acid batteries can create explosive hydrogen gas during normal operation. Keep sparks,
flames and flammable materials away from batteries.
INITIAL SERVICE CHART
Item Service Operation
Portable Charger Remove from vehicle and correctly install.
Batteries Charge the batteries.
Seats Remove the protective plastic cover.
Brakes Check the operation.
Calculate the distance necessary to stop the vehicle for the brake
performance test.
Tires
Check air pressure (
18-22 psi
).
General Check for possible leaks that may have started during shipment.