Cushman Hauler 4x4 Crew Diesel 2019, Руководство оператора

Страница: 43 / 72

41
2. When pure coolant (no air) flows
from the bleed hole, install the bleed
plug and tighten securely.
3. Fill the cooling system to the cold fill
line of the reservoir. Run the engine
for five minutes after the initial fill;
then shut off the engine and recheck
coolant level once cool.
MOD185

NOTE: Use a good quality, biode-
gradable glycol-based, automotive-
type antifreeze.
Shock Absorbers
Each shock absorber should be visibly
checked weekly for excessive fluid leak-
age (some seal leakage may be observed
but it does not indicate the shock is in
need of replacement), cracks or breaks in
the lower case, or a bent shock rod. If any
one of these conditions is detected,
replacement is necessary.

NOTE: When the vehicle is
operated in extremely cold
weather (-23° C/-10° F or colder),
a small amount of leakage may be
present. Unless the leakage is
excessive, replacement is not
necessary.
This vehicle is equipped with adjustable
shock absorbers in the front and rear to
allow for different driving and loading
conditions.
The front shock absorbers or front and
rear shock absorbers have an adjustment
sleeve with five preload adjustment posi-
tions that can be turned with a special
spanner wrench to increase or decrease
coil spring tension.

NOTE: The softest setting is as
shown.
MOD186

NOTE: Before attempting to
adjust suspension, clean dirt and
debris from the sleeve and remove
load from the suspension. Using a
suitable lift or jack, lift the vehicle
enough to allow the shock assem-
bly to fully extend. Use the spanner
wrench to adjust the sleeve to the
desired position.
To adjust the spring force on these shock
absorbers, rotate the preload adjustment
sleeve with a suitable spanner wrench
until desired spring tension is achieved.
CAUTION
After operating the vehicle for the ini-
tial 5-10 minutes, stop the engine,
allow the engine to cool down, and
check the coolant level. Add coolant
as necessary.
Position
Spring
Force
Setting Load
1
Stronger
Soft
Stiff
Light
Heavy
2
3
4
5