Curtis GEM-12D, Инструкции по установке, обслуживание и информация о гарантии, Страница: 7 / 20

REMEMBER… YOUR CURTIS ADS SYSTEM HAS BEEN FACTORY PRE-
SET FOR OPTIMUM PERFORMANCE. GENERALLY THERE WILL NOT
BE A NEED TO CHANGE PROGRAMMING.
In order to change programming you must first confirm that the Sleep Mode is DISABLED. (p8)
7
ENTERING THE PROGRAM MODE
For ALL Functions you must first enter the programming mode.
• Turn OFF the power from the Control Panel by pressing .
• Press and HOLD and Press and RELEASE .
MODE #1
• Continue HOLDING until STARTS blinking; RELEASE.
ON/OFF
ON/OFF
BREW
BREW
READY TO BREW
CONFIRM/RESET BREW TEMPERATURE – Factory Preset to 200F
Enter the Programming Mode #1:
• Press for two seconds; then RELEASE.
• will start blinking. Each blink = 2F starting at 170 . (Max. temp. 204F – 18 blinks).
• To CHANGE TEMPERATURE Press and HOLD .
• will start QUICK Flashing. Each QUICK Flash = Adds 2. After reaching 204 temp starts over at 170 .
• RELEASE when the desired temperature is reached. The newly set temperature will now be
displayed. To set and exit press .
ON/OFF
BREW
BREW
BREW
READY TO BREW
READY TO BREW
STEPS TO
PROGRAMMING
WARNING: These
steps will involve
working with hot
water. Scalding may
occur if care is not
taken against spilling.
TEMPERATURE TABLE
No. of Blinks Temperature No. of Blinks Temperature No. of Blinks Temperature
1 170°F 7 182°F 13 194°F
2 172°F 8 184°F 14 196°F
3 174°F 9 186°F 15 198°F
4 176°F 10 188°F 16 200°F*
5 178°F 11 190°F 17 202°F
6 180°F 12 192°F 18 204°F
*Factory Setting
CHANGING THE ADS™ SYSTEM PROGRAM
Your ADS System features a dynamic memory. In the event of a power loss it will remember ALL program
settings (except Quality Timer).
IMPORTANT – Place an empty container on the warmer deck. Before entering the program mode, allow the unit to
reach brewing temperature, then press one of the BREW buttons on each side to dispense at least 12 ounces of
water. This is to clear any air that may be trapped within the water lines.
BREW TEMPERATURE – FACTORY PRE-SET TO 200°F
This programming function allows you to set brew temperature from 170° to 204°F. Brew temperature will be
indicated by the READY-TO-BREW light blinking. (see chart) Simply follow the steps indicated.