Installation
Connect the Power Cord to the Brewer
1 Place the water tower on a sturdy surface. Remove the
top and side covers.
2 If the brewer will be operating using 120 Vac, locate the
jumper on the terminal block inside the water tower and
remove the cap, then connect the end of the jumper
wire to the L2 terminal on the terminal block.
3 Loosen the strain relief on the back of the brewer.
4 Feed the end of the power cord into the strain relief.
5 Connect the wires on the power cable to the terminal
block inside the brewer.
6 Tighten the strain relief. Leave the covers off until all
the water tower connections are made, later in the
installation process.
Prepare the Countertop
7 Holes must be cut into the counter top prior to installing
the brewer. The hole pattern is critical for proper
operation. See
Figure 3
on the following page. The two
CSFXIFBETNVTUmUXJUIJOBGPPUCZGPPUBSFB
Packed with the unit is a full-size template (Part
# WC-390245). Use the template for cutting the
required holes needed for installing the brew heads,
touchscreen and drip tray. The two largest circular
holes are for the brew head assemblies, along with
three stud holes for the mounting plate for each head.
Also, there is a circular hole for the touch screen, along
with the two mounting holes. The drip tray can be inset
JOUPUIFDPVOUFSPSNPVOUFEnVTI*OTFUJOTUBMMBUJPOJT
recommended. The rectangular hole shown in
Figure 3
is for inset installation. If the drip tray will be mounted
nVTIBDJSDVMBSIPMFJTESJMMFEJOUIFMPDBUJPOTIPXOGPS
the drain instead of a rectangular hole.
Consideration must be made for the drip tray drain
system. The drip tray comes with a 1/2” NPT X 3”
nipple and a 1/2” NPT barbed elbow. Either may be
used to connect the drain system (supplied by the
purchaser) to the bottom of the drip tray. See
Figure 4
on the following page for dimensions.
INSTALLATION INSTRUCTIONS
II12
SERA2, INSTALLATION INSTRUCTIONS
111617A
Figure 1 - Power Cord Connection
Figure 2 - Parts of the Brewing System
(Front View)
Strain
relief
Terminal
block
Water
tower
Right
brew
head
Countertop
UCM/
touch-
screen
Left
brew
head
WARNING:
Make sure power to the circuit supplying
power to the water tower is turned off at the circuit
breaker panel until installation is complete. Lock out
and tag the circuit breaker.
