CAB INSTALLATION
8 of 30
Step 4: (Vehicle Prep)
4.1
Remove and discard the four floorboard bolts
shown in Figure 4.1. If the mower is a
60”,
remove two additional bolts in the location shown.
4.2
Cut the rubber tabs on the floormat at the bolt
locations as shown so that the hole is clearly
accessible.
4.3
Remove the pine tree clips from the floormat at
the 12 locations shown.
4.4
If installing on a
60”
mower, remove and save the
tilting front cover at the front of the machine.
4.5
Install the pedal seal panel on top of the floormat
as shown. Secure to the floorpan using the
following hardware. The floorpan may need to be
lifted slightly in the front on a
60”
mower to access
the center screw.
Hardware Used
Qty
#10
-
32x3/4
”
Phillips Head Screw
6
#10
-
32 Flange Nut
6
Fig. 4.5 (Install Sealing Brushes)
Fig. 4.1 (Remove Bolts)
Fig. 4.2 (Cut Floormat)
Fig. 4.3 (Remove Pine Tree Clips)
60”
Only
Cut Tabs