Curtis Dyna-Fog TYPHOON 2 2985, Руководство пользователя

Страница: 11 / 53

3.2
MACHINE INSTALLATION
1. Remove the machine from the skid and lift the machine onto the vehicle with the
discharge end of the machine toward the rear of the vehicle.
2. Securely mount the machine to the bed of the vehicle using ½” (12mm) diameter
bolts as shown in the diagram on page 12.
3. Pass the remote control unit through an open window and locate it within reach of
the person operating the machine. If permanent vehicle installation is desired, the
remote control cable can be fed through a clearance hole in the vehicle chassis and
then reconnected. When drilling clearance holes, ensure that all sharp edges are
removed and covered to prevent premature wearing of the remote cable. When
routing the cable to the vehicle cab, do not allow the cable to be exposed to any
sharp edges. Avoid sharp bends when routing the cable.
4. Once the cable has been routed to the cab, reseal all drilled openings to prevent
moisture and/or exhaust gases from entering the cab.
11