HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-800-798-0813
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective, CURT
Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the
warranty. CURT Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.Regulation V-5 and SAE J684.
MAZDA MX-5 MIATA
3/24/2016
11435
PAGE 2 of 2
1. Lower exhaust by detaching (5) exhaust hangers. (4) hangers are located on the muffler and (1) hanger is
located forward of the muffler.
2. Using a 10mm socket, remove plastic fascia tab supports attaching fascia tab to bottom of frame rails on driver
and passenger corners of vehicle. Return both supports and (2) support screws to vehicle owner. Retain the
remaining (2) support screws for reinstallation.
3. Enlarge rear mounting hole on the driver and passenger side of vehicle to allow CM-SP2 spacers and 7/16"
carriage bolts to enter into the frame rails.
4. Fishwire CM-SP2 spacers and 7/16" carriage bolts through enlarged holes and out forward mounting holes.
5. Reverse fishwire CM-SP2 spacers and 7/16" carriage bolts into enlarged holes.
6. Raise hitch into position and secure with 7/16" hex flange nuts.
7. Attach 11435-FT brackets to hitch side plates using 1/4" carriage bolts and 1/4" nylock nuts, as shown.
8. Attach driver and passenger side vehicle fascia tabs to 11435-FT brackets using the existing M6 fascia
support screws.
9. Torque 7/16" hardware to 60 lb-ft, 1/4" hardware to 122 in-lb and M6 hardware to 7 lb-ft
10. Raise exhaust back into position and reattach all exhaust hangers.
TOOLS REQUIRED
10mm SOCKET
11/16" SOCKET
7/16" SOCKET
3" SOCKET EXTENSION
RATCHET
TORQUE WRENCH
DIE GRINDER
SAFETY GLASSES
Содержание 11435
Страница 5: ......
