NEED ASSISTANCE?
•
844.278.4357
•
RA
•
PAGE 6
Step 12
If there is no plug in the floor behind the driver
seat, locate a position close to the rear bracket
and drill a 1" hole through the floor of the
vehicle.
WARNING:
Make sure there are no
obstructions in the drilling location.
Once the hole is drilled, take the driver-side
rear actuator (red / black) and the LED light
(brown / tan) and route it down through the
floor. Secure in place with the provided
rubber grommet. Continue to step 13.
Step 13
On the passenger side, take the sensor wire
(gray / green) and route it to the front of the
vehicle underneath the carpet.
Take the passenger-side rear actuator
(red / black) and the LED light (pink / tan)
and route it through the floor plug behind the
passenger seat. If there is no plug in the floor
behind the passenger seat, repeat step 12 on
the passenger-side of the vehicle.
Step 11
On the driver side, take the power wire and
sensor wire (orange / yellow) and route it to
the front of the vehicle underneath the carpet.
If there is no plug in the floor behind
the driver seat, skip to step 12.
If there is a plug in the floor behind
the driver seat continue this step.
Take the driver-side rear actuator (red / black)
and the LED light (brown / tan) and route it
through the floor plug behind the driver seat.
With the rear wires inserted through
the floor hole, cut a slot in the floor
plug and re-insert it into the hole.
Skip to step 13.