Currys ESSENTIALS CFSGSV16, Инструкция по эксплуатации

Страница: 17 / 32

17
Using the Hob Burners
1. Choose the control for the burner you want to use.
2. Press the Ignition switch and at the same time press and hold the Burner control in and then turn it anti-
clockwise to the maximum position. Release the Ignition switch only, once the burner is lit.
Continue to hold the control in for approximately 10 seconds after the burner has lit. Releasing the control
too soon will extinguish the flame due to the flame failure safety feature.
Manual Ignition (in case of electricity failure)
To ignite one of the burners, press and turn the control anti-clockwise so that the control is at the
positions. Hold an ignition source (e.g. candle lighter, spark ignitor) close to the upper circumference of the
burner. Move the ignition source away as soon as you see a stable flame. Continue holding the control in for
approximately 10 seconds after the burner has lit. Releasing the control too soon will extinguish the flame
due to the flame failure safety feature.
3. The control has 3 positions: OFF (O), maximum and minimum . After you have ignited the burner at
the maximum position , you should adjust the flame length for cooking between the maximum and
minimum flame positions. You must not cook with the control between the maximum and OFF (O)
positions.
4. After ignition, check the flames visually. If you see yellow tipped, lifted or unstable flames; turn the control
off, and check the assembly (once the parts have cooled sufficiently) of the burner rings and caps. Also,
make sure that no liquid has entered into the burner cups. If the burner flames go out accidentally, turn the
burners off, and do not try to light them again for at least 90 seconds (to allow the gas to disperse).
5. When turning the hob off, turn the control in a clockwise direction so that the control shows the OFF (O)
position in line with the marking on the control panel.
Flame Failure Safety Feature
The flame supervision device (FSD) probe cuts off the gas supply to the burner if the flame is blown out.
When lighting the burner, hold the control in for approximately 10 seconds after the burner has lit. Releasing the
control too soon will extinguish the flame.
If the flames are accidentally extinguished, turn off the burner and do not try to light it again for at least 90
seconds (to allow the gas to disperse).
• If the burner does not light within 15 seconds, turn the control off and wait for at least 90 seconds
before trying again.
• To switch the burner off, turn the control clockwise to the OFF (O) position.
• After use, always turn the controls to the OFF (O) position.
This appliance is for cooking purposes only. It must not be used for other purposes, for example
room heating.
CFSGSV16_WH16_IB.indd 17 04/04/2016 17:44