Cable connection to driver
Connect the WIT100 Sensor Digital bus line with a TE770340 / TE350628 connector to the bellow drivers and interface module:
Cable from Driver/Interface module
•
Connected Indoor Driver (CID): limited compatibility to allow proper operation of fixture (OFF, backround level dim and task level lighting)
and OTA
•
Philips Sensor Ready driver (SR): compatibility desirable but not required
•
Leedarson 0-10V/DALI interface module: ON/OFF and dimming commands only (no Fault Reporting, no VLC, no Dimming Curve Change,
no 1% diming, partial UL924)
www.currentbyge.com
All trademarks are the property of their respective owners. Information provided is subject to change without notice. All values are design or typical values
when measured under laboratory conditions. Current, powered by GE is a business of the General Electric Company. © 2016 GE.
WIT100 Sensor Install Manual (GE2033-0758 / SAPXXXXXXXX)
Dimensions
Sensor pattern
