25
5. Set the Final Position- Full Open
Twist the E-Wand TWIST HANDLE in the
OPPOSITE direction [Fig. 6.8] to move
the slats back to the FULL OPEN position.
Press and hold the PROGRAMMING
BUTTON b until the slats begin to move
[Fig. 6.9].
The slats will automatically move LEFT
and back to the FULL OPEN position
to confirm positions have been set
properly and that you have completed
programming the slat positions.
Note: During twisting, if you move past the full open position, do not
twist the opposite way back to full open. Instead, restart programming.
To get out of programming mode, power cycle the unit by unscrewing and
re-tightening the battery cap. You have successfully power cycled when you
hear a tune.
Figure 6.8; Twist
Blinds to Full
Open
Figure 6.9;
Push and Hold
Programming
Button
You have now completed setting the open and close limits on the
E-Wand. You are now ready to add the E-Wand onto a Zigbee Network,
if desired [Pg. 26].
