Led Display States:
Red Led Flash: There is no label defined on the Control Card, the memory is empty.
Red LED is steady: There is a defined label (s) on the control card.
Blinking Blue Led: It gives a warning when an unidentified card is read or when you have the same
card read again in identification mode.
White Led Flash: When the master card is scanned, the identification mode becomes active and the
White Led flashes.
Yellow Led Flash: Yellow Led flashes 5 times when the card is recognized while the identification
mode is active.
Green Led steady: When the identified card is read, the Green Led lights up and the relay output
becomes active.
ATTENTION: RF ID Antenna becomes active 20 seconds after energized. In this case, the LEDs on the
control card light up green-red-blue and the antenna is expected to be ready. At the end of 20
seconds, the system becomes ready by giving an audible warning
.
Add Tags:
A-
Adding Tag with Master Card: Master card is shown to RF ID antenna, white LED flashes on
the control card and identification mode becomes active. The cards to be introduced are
read to the RF ID antenna, respectively. For the card whose recognition process is successful,
the led on the control card lights up yellow and flashes.
B-
If the introduced label is tried to be add again, the blue led will flash and warn. If there are
no more tags to add, wait, the device automatically exits the identification mode and gives
an audible warning.
C-
Adding Label with Button: Press the load button without taking your hand until the LED light
flashes White. If the white LED flashes, it means that the introduction mode has been
activated. Repeat the above-mentioned introductions.
Deleting a Label:
While the control card has no power, keep the loading button pressed and feed the card. A long beep
is heard with white light. If the deletion is successful, the led light will turn red and flash.
Note: The master card is never deleted, it can only be changed.
Master Card Replacement:
The master card is shown to the RF ID antenna or the identification mode is switched by pressing the
load button.
While the introduction mode is active, the loading button is pressed 5 times in a row and pulled. At
the end of this process, the White LED flashes. If the tag we want to make a master card is shown to
the RF ID antenna, the led flashes yellow, it means the master card replacement is successful.
