6
JetScan
®
D
A
I
L
Y
C
L
E
A
N
I
N
G
7
JetScan
®
D
A
I
L
Y
C
L
E
A
N
I
N
G
Starting from the top and moving
to the bottom, use a microfiber towel
or vacuum to clean both sides of the
paper path.
Be sure to clean the two sensors and two
reflectors in the paper path.
Use a Simple Green Safety Towel
to clean all rubber sections of the
large, black feed rollers. Rotate the rollers.
Also clean the flat, center rubber-drive tire.
Center rubber-drive tire
9
8
Black feed
rollers
Center rubber-
drive tire
Rotating the large, black feed rollers will rotate all other shafts
and rollers in the machine. These rollers can be rotated in either
direction by using fingers. Generally, the top of these rollers
should be rotated forward (direction of note flow), so any dirt
or stray material is moved out of the unit.
Paper Path
Reflector
Sensor
If there is heavy buildup on the aluminum
rollers, remove it with a clean, soft eraser
as shown below.
Use a Simple Green Safety Towel
to remove dirt buildup from the
upper and lower aluminum rollers. To
reach all exposed surfaces, rotate the
large, black feed rollers forward (direction
of note flow).
7
In pockets one and two, use a
microfiber towel or vacuum to clean
the stacker-sensor lens located between
the two gray stacker wheels.
10
11
Push the front enclosure back until it clicks into its normal
operating position.
