Part No. 4801-1020 Rev 2-2015
Super-Saver XL 250 Heater
– 120 Volt, 60Hz, ETL
Page
6
of 22
3.
Warnings and Cautions
C A U T I O N !
1. Installation must conform with local, state, and national codes, or in the absence of local codes, with the
Standard for the Storage and Handling of Liquefied Petroleum Gases
, in accordance with ANSI/NFPA 58
and/or the
National Fuel Gas Code
, ANSI Z223.1, as applicable.
2. Follow safety, maintenance, and test firing instructions packaged with Heater.
3. Refer to model specifications label for gas type (LP or Natural Gas).
4. Check all connections for gas leaks.
5. Gas supply and regulator must be installed outside building.
6. The hose assembly should be protected from traffic, building materials, and any contact with hot surfaces
both during and while in storage.
7. Do not open heater doors, or remove a heater panel, or move or handle the heater while it is operating,
hot, or connected to power supply.
8. Turn power off before servicing. (Heater may start at any time if power is connected).
9. Heater is not recommended for heating human living quarters.
10. Not to be used for heating where flammable liquids and vapors are stored or used.
11. Inadequate gas volume and (or) pressure will directly influence the combustion efficiency of the heater.
Adequate gas volume and (or) pressure is the responsibility of the installer.
12. Adequate ventilation is required.
13. Combustion and ventilation air must not be obstructed.
14. Not for use with duct work other than types provided by manufacturer.
15. Position heater properly before use. Heater must be level and in accordance with minimum clearances.
16. For safety, this heater is equipped with air flow proving switch and manual-reset high limit switch.
17. Keep temperature of fuel containers below 100° F (37.8°C). Containers must be installed outside
building.
18. Heater must not be operated for one hour following wash-down.
WARNING
When Heater Is Connected To Remote Thermostat
Heater May Start At Any Time!
ELECTRICAL GROUNDING INSTRUCTIONS
This appliance is equipped with a three prong (grounding) plug for your
protection against electrical shock and should be plugged directly into a
properly grounded three-prong receptacle. Failure to use a properly grounded
receptacle can result in electrical shock, personal injury or death.
