Cumberland EDGE 890-00601, Инструкция по установке и эксплуатации

Страница: 77 / 258

9
Curves and schedules
Topics Covered in this Chapter
▪ Curves
▪ Schedules
▪ Creating curves
▪ Adding an existing curve
▪ Duplicating a curve
▪ Deleting a curve
▪ How it works: Light schedules and programs
▪ Light curves
▪ Motor curve types
Curves
When you want a system value to change over time, rather than remain static, a curve is used. Curves
can be used for many different system parameters, such as temperature set point (for example, tempera-
ture set point changes as the animal ages) or heating/cooling on/off settings. Curves are used extensively
in the EDGE controller. Curves can be made up of absolute values or offsets. The units used in the
curves are related to the type of curve created.
Curve types
Table 9-1 Curve types with x and y axis
Set point Type Description
House/barn temperature Absolute House/barn temperature set point
Cooling Offset Cool cells, mister, foggers, drippers
Absolute Cool cells using external temperature for control
Heating Offset Heaters, all types
Brooding
Offset
Brooders, all types
Absolute Brooders, all types
Relative humidity Absolute House/barn relative humidity
Power ventilation - CFM
Absolute Minimum ventilation
Power ventilation - CFM/hd Absolute Minimum ventilation
Power ventilation - BW Absolute Power ventilation
Natural Ventilation Absolute /
offset House/barn Natural ventilation
Tunnel Ventilation Absolute /
offset House/barn Tunnel ventilation
Water spill Absolute Detects water spill event
Auger maximum run time Absolute Detects food delivery issue
895-00693 EDGE 77